Glove former cleaning machine is an important part of the glove production line. The intelligent glove former cleaning system cleans the chemical substances and impurities on the glove former. In order to ensure the quality of the glove, the glove former needs to be completely cleaned before impregnating the raw material. After more than ten years of continuous testing and improvement, the Fengwang glove former cleaning system can remove the chemical substances and residues on the nitrile/latex /PVC glove former, which is conducive to the manufacture of higher quality gloves.
Glove former is usually made of ceramic, metal or plastic and is used in all stages of glove production. A dirty glove former can lead to defects such as tearing or uneven thickness. In addition, the chemical residue on the glove former will affect the adhesion of glove materials, resulting in defective gloves, which will cause waste of raw materials and increase production costs. A well-maintained production line runs smoother and faster to achieve higher yields.
(1) Lye configuration: the sodium hypochlorite, sodium hydroxide, water into the mixing tank configuration into 30% concentration of liquid, according to the specified amount of input into the production line alkali tank, the line of hand mold cleaning.
(2) Acid preparation: put 30% nitric acid into the discharge tank, and then transport it to the production line according to the specified amount, and clean the hand mold on the line.
Hand model cleaning: Hand model through online pickling, alkali washing, and then through washing and brushing to ensure that the hand model is clean before dipping, and then after drying, ready to dipping.
Fengwang Glove Former Cleaning Machine
Glove former cleaning machine structure
The glove former cleaning machine is a fully automatic glove former cleaning system. Under normal circumstances, the glove former cleaning system comprises a pickling tank, an alkali washing tank, a cleaning mold disk brush and cross brush, and two heating sinks.
Glove Former Cleaning Machine Material
Fengwang manufacturing these gloves production equipment is made of high quality materials. Among them, the function of the disk brush and the horizontal brush is to clean the stains on the hand model, and they are required to clean the stains on the hand model accurately without damaging it.
Therefore, the disk and horizontal brush are usually made of engineering plastic and nylon plates. The horizontal brush is used to clean the glove former’s palms and fingers, and the disc brush is used to clean the glove former’s wrists and above.
The heating tank is a single-layer direct heating tank made of 3mm sus304 stainless steel. In general, the capacity of each tank is manufactured according to the process requirements.
Glove Former Cleaning Machine Cleaning Process
Each slot function of the automatic glove former cleaning system is different. The glove former is immersed in the pickling tank to clean the residue on the mold, and the glove former is passed through the alkaline cleaning tank to clean and neutralize the acidic water on the mold. After that, the glove former went into the washing and cleaning mode to ensure the initial cleaning effect of the mold. Finally, the glove former went through two hot sinks to wash the dust on the mold, so that the glove former was completely cleaned.
Heating Water Tank Design
The heating sink is made of SUS304 stainless steel pipe as a heating coil, the coil is directly placed at the bottom of the tank of the heating sink, and the cleaning liquid is heated by the way of wall heat dissipation to achieve the best constant temperature effect.
The above is the cleaning process of the glove former cleaning machine. A high-quality Inspection gloves production requires a clean glove manufacturing plant and non-contaminated hand molds. If you need a glove former cleaning system now, please contact us immediately.